Overviews

Commands

See Also

To program a device in the SignalTap^® II Logic Analyzer: Read This First

1. If you have not already done so, perform an analysis and synthesis, an analysis and elaboration, or a compilation on the design.

2. If necessary, open a SignalTap II File (.stp), or create a new STP File.

3. If you have not already done so, set up the STP File.

4. Save the STP File.

5. Compile the STP File with the selected project.

6. Select a communications cable.

7. Under JTAG Chain Configuration, in the File list, select an SRAM Object File (.sof). More Details

8. In the Device list, select the device to which you want to download the design.

9. If you modify the devices on the circuit board and want to scan the new devices, perform the following steps:

   1. Click Scan Chain.

   2. In the Device list, select the device to which you want to download the design.

10. Click the Program Device button .

11. Run the SignalTap II Logic Analyzer.

Back to Top